More progress

So, the frames for the upper doors have been cut. In the picture they are all just sitting there, nothing is actually attached together. Yesterday I made a mortising jig for the table saw, and I think it works rather well. The backs are already rabbeted for the warlon and plexiglas.

Next up is the little stuff, like the notching for the strips that will make up the pattern in front of the warlon. I think those are going to be done by hand after I rip them down to size. Once those are cut then I can dye/assemble and lacquer the parts before installing the plexi and warlon before sticking them in the cabinet. I also need to order the mirror and the shelves for the bottom sections.

I still have to do the doors on the base cabinet but those will wait a bit, I hope to get some of the needed hardware (hinges, drawer slides) at the Woodcraft bag sale next weekend.

Too bad I don't have tomorrow off to work on it, and I'm not sure how much more energy I have left for tonight. I might just have to re-position the heaters to be pointing right at me and setup a single workstation.